Senix GTC4QL-L Manual Del Operador página 7

Cortador a gasolina con motor de 4 ciclos de 1.62 pulg. cúb. 26.5 cc
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTALL THE FRONT HANDLE
1.
1. There are 3 positions where the front handle can be
fixed with 4 screws as shown in the image above.
Select the suitable position according to the body
height of operator.
2. Screw the handle and holder (1) using the screw
driver provided. The screws and holder are pre-
attached to the front handle.
3.Tighten the 4 screws until the handle is secure.
NOTE: The front handle could be only fixed in the 3
positions. Failure to fix the front handle can cause
serious personal injury.
INSTALL THE HARNESS
The straight-shaft trimmer harness with quick release
function can be hooked behind the rear hand if needed.
NOTE: Harness use is optional.
WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a
second is sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1, along with hearing protection.
Failure to do so could result in objects being thrown into
your eyes and other possible serious injuries.
WWW.SENIXTOOLS.COM
2.
7

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Gts4ql-l

Tabla de contenido