Nilo SPA MET Manual De Empleo página 23

USE
1 - Plug in the power cable to a suitable outlet (1).
2 - Set onto ON the General Switch (2) situated in the lower part of the
bed.
3 - Ad just the bed height, the inclination of the back (3) and the leg
support (4) using the remote control (5).
4 - Get the Client to lay on the bed
ADJUSTING THE BACK AND THE LEG-SUPPORT
The adjustment of the bed height, the inclination of the back, and the
leg-support are achieved electrically in all of the three models.
Adjustment management is performed through four electric motors
(one to manage the movements of the back, one for the leg-support, two
motors to manage the height of the bed).
Adjusting is performed by the beauty specialist with the supplied remote
control.
(A) – Green led – Power presence
(B) – Continuous press button – Uplifting of the back
(C) - Continuous press button –Lowering the back
(D) -Continuous press button – Uplifting of the leg-support
(E) -Continuous press button – Lowering the leg-support
(F) - Continuous press button – Simultaneous uplifting of both the back
and the leg-support
(G) - Continuous press button – Simultaneous lowering of the back and
the leg-support
(H) - Continuous press button – Uplifting of the bed
(I) - Continuous press button – Lowering the bed
Every time the use of the remote control is over, make sure it is placed
back on its related anchorage device (6) located on the side on the bed.
20