Flash Detection Mode - Bpt IT/300 Manual De Instrucciones

Lift the receiver
or
press the hands-free key.
Following this operation, a double tone
should sound, prompting you to commence
programming.
ABC DEF
1 2 3
GHI JKL MNO
4 5 6 Key in 9999.
PQRS TUV WXYZ
7 8 9
0
To end the programming session from the
XA/300LR power supplier, press the SERVI-
CE button for 1 second.
To end programming from X1/X2 systems,
close the jumper SW2 on the entry panel.
PROGRAMMING

Flash detection mode

Following this operation, a double tone
should sound, prompting you to commence
programming.
ABC
2
0
1
Once finished, you should hear a triple tone
confirming the setting.
25
Lift the receiver
or
press the hands-free key.
Key in 20.
0
Press 0 for type approved
flash detection
or
1 for long flash detection.
Replace the receiver
or
press the hands-free key.