Publicidad
Idiomas disponibles
Idiomas disponibles
2
Carefully lift tunnel
assembly and position it
at the desired location
making sure it is level.
Press firmly for 10
seconds at each clip
location along the
length of the assembly
to secure the clips
and clip
18
the wall.
3
18
20
19
to
19
18
Peel the tunnels
away from
20
the clips
18
and
.
19
20
4
18
Arrange your wires on
either side of the clips.
Reattach the tunnels
to the clips
20
20
clip
19
capture the wires behind
19
them. Press firmly along
the length of the tunnels
where the clips are located
until clips snap in place.
NOTE: Leave enough slack in
the cables/wires above the tunnel to
prevent them from interfering with
20
or rubbing against the tunnel when
moving the TV. This could cause the
tunnel to separate from the clips.
TIP: Taping the cables/wires in
place above and below the tunnels
to hold them will make reattaching
the tunnels easier.
and
18
making sure to
15
Publicidad
