Display Information; Liquid Crystal Display; Radio Operation; Switching To Radio Mode - Lenco CS-321 Manual Del Usaurio

OPERATION

DISPLAY INFORMATION

- Press DISP button (9) to show the time.

LIQUID CRYSTAL DISPLAY

AUXILIARY INPUT
The unit can be connected to a portable
audio player through the AUX IN jack (13).
USB INTERFACE
On the front panel of the unit, there is an
USB interface (12). You can connect an
USB driver through this interface (12).

RADIO OPERATION

SWITCHING TO RADIO MODE

Press MODE button (11) shortly to select
radio mode, the radio mode appears in the
display together with the memory band and
frequency.

SELECTING THE FREQUENCY BAND

At radio mode, press BND/LOU/ENT
button (4) shortly to select the desired
band.
The reception band will change in the
following order:
FM1 FM2

SELECTING STATION

Press button (2) or
shortly to activate automatic seek function.
Press for several seconds until "MANUAL"
appears on the display, the manual tuning
mode is selected. If both buttons have not
been pressed for several seconds, they will
return to seek tuning mode and "AUTO"
appears on the display.
AUTOMATIC MEMORY STORING &

PROGRAM SCANNING

-

Automatic memory storing

Press AS/PS button (10) for several
seconds, the radio searches from the
FM3 MW1 MW2
button (24)
current frequency and checks the signal
strength until one cycle search is finished.
And then the strongest stations are
stored into the corresponding preset
number button.
- Program scanning
Press AS/PS button (10) shortly to scan
preset station. When the field strength
level is more than the threshold level of
stop level, the radio is holding at that
preset number for several seconds with
release mute, then searches again.

STATION STORING

Press any one of the preset buttons (18) (1
to 6) to select a station, which had been
stored in the memory. Press this button for
several seconds, current station is stored
into the number button.
RDS FUNCTION
1.AF / REG
- AF / REG key directs the activation of
AF SEARCH.
- AF indicator is displayed when AF is
ON, AF search is activated when
reception is bad.
- During FM MODE,when AF is ON,
SEEK, SCAN,
function can only receive and save.
2.TA is turned ON / OFF and TA indicator is
displayed.
When traffic announcement is
transmitted, regardless of the mode,
traffic announcement is received.
- when TA is on, SEEK,SCAN, AUTO
MEMORY function can be received or
saved or saved only when traffic
program identification code has been
received.
-
-
23
AUTO, MEMORY