Fermax DUOX Manual De Instalación página 28

DUO DUO X Pr X Pr o o o o o g g g g g r r r r r amming X Pr
DUO X Pr DUO DUO X Pr
DUO DUO X Pr X Pr o o o o o g g g g g r r r r r amming X Pr
DUO X Pr
DUO DUO X Pr
2. Sequential Programming. (Only 1 operator is required).
This mode allows call codes (addresses) to be assigned
sequentially in whatever order you require.
The steps to be followed are detailed below:
1. Previously configure the panel as MASTER panel, (see
previous pages).
2. Select the «sequential button programming» mode on
the amplifier.
Press the SW1 button and hold for 10 seconds until you
hear a «beep.» If you hold for 5 more seconds you
hear a double ''beep'' and upon releasing theLed Mode
(DL2) is activated to indicate that we entered in an
sequential programming mode (slow blink: 1 flash /
second 50%).
3. Assign the new addresses to each button:
Press the call buttons in whatever order you wish to assign
the codes on the entry panel, starting with 0, and running
sequentially upward.
- 1 Press = Code 0.
- 2 Presses = Code 1.
- 3 Presses = Code 2.
- and so on.
The amplifier stores each of the buttons' new call codes.
Pag 28
amming amming
amming amming
amming amming
amming
amming