Switch Housing Assembly; Remote Control; Important - Craftmade ELLINGTON COL72BP6 Guia De Instalacion

9. Switch Housing Assembly.

Remove 4 screws from outer edge of switch
housing plate (save screws for later use).
Remove 1 screw from fitter plate on underside of
motor and partially loosen the other 2 screws.
Align slotted holes in center of switch housing
plate with loosened screws in fitter plate,
allowing molex plugs from motor housing to
come through hole in middle of switch housing
plate. Twist switch housing plate to lock. Re-insert
screw that was removed and secure all 3 screws.
Align holes in switch housing cap with holes in
switch housing plate. Re-insert screws that were
previously removed and use a Phillips screwdriver
to secure all 4 screws.
10. Automated Learning Process./Activating Code.

remote control

2
IV
III
II V
1
I
VI
3
4
6
ON ECE
5
1 2 3 4
12V
BACK
["Automated Learning Process/Activating Code" continued on next page.]

IMPORTANT:

Remote and wall
controls must be
SYNCHRONIZED with
fan in order to
properly function.
5
IMPORTANT:
The code switches in
remote and wall
SET
controls MUST MATCH
for fan to function
properly.
motor housing
fitter
plate
wall control
5
6
FRONT PANEL
page 8
molex
plugs
switch housing
switch
housing cap
2
III IV
1
II V
VI
I
3
4
7
OFF ON
5
12V
plate