Controls - GE GTD84ECSNWS Manual Del Propietário

Getting started
Features and appearance will vary.
Power
A
Press to "wake up" the display. If the display is active, press to put the dryer into idle mode.
NOTE: Pressing Power does not disconnect the appliance from the power supply.
Start and Pause
B
Press Start to begin the cycle. NOTE: The door must be closed for the dryer to start the cycle. Pressing Start
again will pause the cycle, the Start light will blink and "Pause" will display.
To continue the cycle, press Start again.
Display and Status Lights
C
The display shows the approximate time remaining until the end of the cycle.
In addition, this display will show the dryer status:
Pause
(on some models)
WiFi
(on some models)

Controls

Sensing
Clean Lint Filter
Check Vent
(on some models)
6
A
B
A
B
The Start/Pause light will flash and the message "Pause" will show in the display when
the dryer's cycle is paused. The cycle may be re-started by pressing the Start button.
Will allow your appliance to communicate with your smartphone for remote appliance
monitoring control and notifications.
The dryer is locked - will blink once if you press any button or turn the cycle knob.
Indicates the dryer is sensing the level of dampness to determine estimated cycle time
remaining.
The Clean Lint Filter light will stay on for 15 seconds after the cycle stops.
The Check Vent light indicates an issue has been found due to reduced airflow from a possible
blocked or restricted vent. Checking and/or cleaning the vent system is recommended. See the,
"Check Vent" light is on in the Troubleshooting Tips section.
E C
F
E C G
Cycle Status:
Sensing Controls
Drying
90 min.
Cooling
60 min. More Dry
Pause
40 min.
Damp
20 min. 20 min. Less Dry
On 10 min.
E I H D F
G
D H I
Est. Time
Remaining
Clean
High Lint Filter
Dry Medium Check Vent
Low
Damp No Heat
H
H
49-3000198-1