Cub Cadet 19A70054100 Manual Del Operador página 10

Install Hanger Assembly - Double
Bagger Models
For model numbers 19A70054100 and
19A70055100, follow the steps below. For Triple
Bagger model number 19A70056100, skip to
the next section.
1. Install and secure the hanger assembly
onto the upright support bracket using
two carriage bolts (710-0276) two cup
washers (736-0242) and two flange lock
nuts (712-04063) from hardware pack
689-01419. See Figure 4-7.
Figure 4-7
NOTE: The carriage bolts (710-0276),
from hardware pack 689-01419, go in the
top hole with the nut facing the engine.
The hex bolt (710-0376), from the same
hardware pack, goes in the bottom hole.
Install Hanger Assembly - Triple
Bagger Model
For model number 19A70056100, follow the
steps below.
2. Install and secure the hanger assembly
onto the upright support bracket using two
carriage bolts (710-0276) two cup washers
and two flange lock nuts (712-04063 ) from
hardware pack 689-01419. Figure 4-8.
Figure 4-8
10 S 4 — A
ection SSembly
NOTE: The carriage bolts (710-0276),
from hardware pack 689-01419, go in the
top hole with the nut facing the engine.
The hex bolt (710-0376), from the same
hardware pack, goes in the bottom hole.
Install Top Bagger Components-
Double Bagger Models
For model numbers 19A70054100 and
19A70055100, follow the steps below. For
Triple Bagger model number 19A70056100,
skip to the next section.
With the mounting brackets assembled and
in place on the tractor, follow these steps to
assemble the remaining bagger components.
1. If not already installed by the factory,
snap the vent cover into the holes
found on the chute support assembly.
2. Snap the plastic upper chute support in place
by first clipping the side portion onto the
bagger support rail (1) as shown in Figure 4-9.
3. Snap the front side of the chute support
to the rail (2) as shown in Figure 4-9.
4. Snap the top cover support onto the bagger
support rail at a slight angle. Rotate the
assembly down and into the chute support
assembly, making sure that the tab (shown in
inset of Figure 4-10) is locked into place.
& i
nStAllAtion
Figure 4-9
Figure 4-10
5. Install the bagger top cover by aligning the
tabs of the cover and sliding the mounting
pin into the channel as shown in Figure 4-11.
Figure 4-11
6. Open hood by pushing in on the rear
side tabs with your hand (1), and lifting
the cover with your other hand in the
center rear of the bagger cover (2) as
shown in Figure 4-12.
Figure 4-12
7. Install both bag assemblies onto the bag
support brackets by inserting the front
edge in first (1), and then setting the back
edge down until it fits into the assembly
(2) as shown in Figure 4-13.
Figure 4-13