Cub Cadet 19A70054100 Manual Del Operador página 12

2. With the tractor's discharge chute raised
up and held open (1), install the chute
elbow by placing the chute elbow
mounting rod into the chute mounting
tab (2), as shown in Figure 4-21.
1
Figure 4-21
3. Secure the chute elbow to the deck using
a wing knob (720-04122) from hardware
pack 689-01419. See Figure 4-22.
Note: If present, remove the protective
cap off of the mounting stud on the
mowing deck as shown in the upper
inset of Figure 4-22.
2
Figure 4-22
Important! Be certain that the bottom of the
discharge chute is located inside of the lip of
the deck opening, as shown in Figure 4-23.
Figure 4-23
12 S 4 — A
ection SSembly
Installing the Discharge Chute -
19A70055100 & 19A70056100 50/54"
Double and Triple Baggers
When installing the discharge chute, two
different installation instructions exist. For the
54" Fabricated deck units, the discharge chute
elbow mounts directly onto the cutting deck.
For the 50" and 54" stamped decks, an adapter
must first be installed. Be sure to follow the
instructions that pertain to the unit you are
installing this bagger on.
2
54" Fabricated Deck Units:
1.
2.
1
3.
4.
5.
& i
nStAllAtion
Raise the deck to its highest position.
Raise the chute deflector (1 in Figure
4-24) on the deck and hold it while you
position the discharge chute over the
chute opening.
1
3
2
Figure 4-24
Insert the end of the discharge chute
elbow (2) into the hole provided in the
deck wheel mount as shown in the inset
of Figure 4-24.
Pivot the discharge chute rearward until
the hole in the discharge chute elbow
aligns with the pin on the deck. Move the
discharge elbow down onto that pin as
shown in 3 of Figure 4-24.
Secure the discharge chute elbow to the
cutting deck using a (720-04122) wing
knob included with the bagger kit. Refer
to Figure 4-25.
Figure 4-25
On 50" and 54" Stamped Decks:
1. Raise the deck to its highest position.
2. Remove the deck pin rubber protective
cap, 1 in Figure 4-26.
3. Raise the chute deflector (2 in Figure
4-26) on the deck and hold it while you
install the (731-10133) chute adapter (3),
included in hardware pack 689-01419,
onto the deck as shown in Figure 4-26.
2
3
1
Figure 4-26
4. Insert the end of the discharge chute
elbow (1) into the hole provided in the
deck wheel mount as shown in the inset
of Figure 4-27.
2
Figure 4-27
5. Pivot the discharge chute rearward until
the hole in the discharge chute elbow
aligns with the pin on the deck adapter.
Move the discharge elbow down onto
that pin as shown in 2 of Figure 4-27.
1