Cub Cadet 19A70054100 Manual Del Operador página 13

6. Secure the discharge chute elbow to the
cutting deck using a (720-04122) wing
knob included in hardware pack 689-
01419. Refer to Figure 4-28.
Figure 4-28
Installing the Upper Chute Tube - All
Models
1. Thread the upper end of the chute tube
securely into the upper chute support.
There are two tabs on the lower inside
part of the upper chute support to allow
for secure threading. See Figure 4-29.
NOTE: The chute tube and upper chute
support are left-hand threaded. Thread
counterclockwise until secure.
Figure 4-29
2. Lift by the handles at the bottom of the
chute tube. Slide the chute tube over the
chute elbow mounted on the cutting
deck, as shown in Figure 4-30.
Figure 4-30
3. Make sure the connection is secure and
there are no gaps between the chute
tube and the chute elbow.
4. If open, close the grass catcher cover
prior to mowing.
Install The Counter Weight
WARNING:
This front-weight kit
is required when operating any
compatible RZT models equipped
with a grass collector. Failure to
install this kit may result in serious
injury or death.
WARNING:
Before beginning
installation, place the RZT on a
firm and level surface, set the
parking brake, place the PTO in
the disengaged (OFF) position,
stop the motor and remove the
ignition key to prevent
unintended starting.
5. Before assembly, peel the adhesive
decals from the sheet and apply to the
inside faces of the right and left weight
hanger brackets, as shown in Figure 4-31.
Figure 4-31
6. Attach the weight and three weight
plates to the weight hanger brackets
with two 3/8" Hex head capscrews (710-
3085) and two nuts (712-04065) as shown
in Figure 4-32.
Figure 4-32
7. Visually center the weight bar assembly
on the tractor and using two 5/16" Hex
head capscrews (710-3056) and two nuts
(712-04063) secure the counter weight
assembly to the tractor as shown in
Figure 4-33.
Figure 4-33
S 4 — A & i
ection SSembly
13
nStAllAtion