Cub Cadet 19A70054100 Manual Del Operador página 11

Install Top Bagger Components-
Triple Bagger Model
For triple bagger model number 19A70056100,
follow the steps below to install the bagger
components.
With the mounting brackets assembled and
in place on the tractor, follow these steps to
assemble the remaining bagger components.
1. Snap the plastic upper chute support in
place by first clipping the side portion
onto the bagger support rail (1) as shown
in Figure 4-14.
Figure 4-14
2. Snap the front side of the chute support
to the rail (2), as shown in Figure 4-14.
3. If not already installed by the factory,
install the bagger screen into the
bagger cover by first inserting one end
into the corresponding cutout mounting
hole. Make sure to feed the screen under
the lip, as in Figure 4-15.
Figure 4-15
4. Install the bagger cover onto the bag
support assembly, as seen in Figure 4-16.
The plastic cover goes inside the two
mounting tabs.
Figure 4-16
5. Slide the hinge pin into the hole located
on the mounting tab, as shown in Figure
4-17. Use the cut-out windows (See inset
in Figure 4-17) to line up the hinge pin on
the other side and push pin all the way in
until it reaches the end-stop. At this point
the pin clips into place and is secured by
a tab in the bagger cover.
Figure 4-17
6. Open hood by pushing in on the rear,
right-side tab with your right hand (1),
and lifting the cover with your left hand
in the center rear of the bagger cover (2)
as shown in Figure 4-18.
Figure 4-18
7. Install all three bag assemblies onto the
bag support brackets by inserting the
front edge in first (1), and then setting
the back edge down until it fits into the
assembly (2) as shown in Figure 4-19.
Figure 4-19
Installing the Discharge Chute -
19A70054100 42/46" Double Bagger
1. Install the boot rod mount (747-06043) to
the boot using 2 shoulder screws (738-1225)
and 2 flangelock nuts (712-04064) from
hardware pack 689-00636. Ensure that the
shoulder screws (738-1225) are installed on
the interior of the boot. See Figure 4-20.
Figure 4-20
S 4 — A & i
ection SSembly
11
nStAllAtion