Shutting Down Pressure Washer; Usage Of Cleaning Detergents - Snap-On 870968 Manual De Instrucciones Para La Instalación, Uso Y Mantenimiento

• If you get spray nozzle too close, especially using high pressure mode, you may damage
surface being cleaned.
• DO NOT get closer than 6 inches when cleaning tires.
The Pressure Washer motor runs only when the trigger is engaged. To shut off the
Pressure Washer:
1. Release spray gun trigger.
2. Move unit's ON/OFF switch to OFF position.
IMPORTANT: Releasing the trigger will shut off the motor but does not shut off electrical
power to the unit.
3. Turn off water supply.
4. ALWAYS point spray gun in a safe direction and squeeze spray gun trigger to relieve built
up pressure in the unit. Release spray gun trigger.
and water is disconnected.
5. Engage trigger lock on spray gun when not in use. Place the gun in its holder on the side
of the unit.
6. Disconnect GFCI plug from outlet and wrap power cord around the Power Cord Hook at
the back of the pressure washer. Store the GFCI plug inside its housing in the center of
cord intake.
7. Disconnect pressure washer from water supply and store the unit (see MAINTENENCE sec-
tion).
TO APPLY DETERGENT:
1. Select a detergent/cleanser appropriate for the intended application.
2. Prepare detergent solution as recommended by the manufacturer.
3. Remove the detergent tank lid located at the top of the Pressure Washer.
4. Fill tank with prepared detergent solution. A small funnel may help with this task. Replace
the detergent tank lid.
5. Set (turn) the Pressure Adjust Collar to low pressure position.
(turned) to low pressure position.
6. Pull spray gun trigger and apply detergent to a dry surface, starting at lower portion of area to
be washed and work upward, using long, even, overlapping strokes.
SHUTTING DOWN THE PRESSURE WASHER
Spray gun traps high water pressure, even when motor is stopped

USAGE OF CLEANING DETERGENTS

Detergent will NOT flow until the Pressure Adjust Collar is set
14