Snap-On 870968 Manual De Instrucciones Para La Instalación, Uso Y Mantenimiento página 20

Problem
Unit will not start (when trig-
ger is depressed)
AC outlet circuit breaker trips
TROUBLESHOOTING GUIDE
Probable Cause
5. No AC power at the outlet.
6. Main voltage supply is too
low.
7. Extension cord is too long
or wire size too small.
8. Defective ON/OFF Switch.
9. Defective GFCI Plug.
10. Defective Gun.
1. Circuit (outlet) overload-
ed.
2. Extension cord is too
long or wire size too
small.
3. Nozzle partially blocked
causing
excessive pressure.
18
Solution
5. Main circuit breaker is
tripped or outlet is faulty.
6. Make sure main supply
voltage is adequate (See
specifications).
7. Remove extension cord or
use proper extension cord
(See instructions).
8. Call Customer Service:
1-888-278-8092.
9. Call Customer Service:
1-888-278-8092.
10. Turn off the unit. Remove
the Gun and Hose assem-
bly from high pressure
outlet in the back of the
unit. Redirect the outlet to
a safe direction and switch
ON the unit. If the unit
starts and water comes out
of the front, the Gun may
need to be replaced. Call
Customer Service:
1-888-278-8092.
1. Make sure circuit is rated
at 15 amps or greater and
unit is plugged into a
dedicated circuit.
2. Use proper extension
cord (see instructions).
3. Clean Nozzle (see
instructions).