2. Set the nozzle to high pressure setting to make the noz-
zle hole accessible.
3. Clear blockage in nozzle by inserting the nozzle cleaning
needle (provided) through center hole.
4. After cleaning, remove the needle from nozzle and store
for future use.
LUBRICATION
This Pressure Washer does not require any maintenance on the pump or motor. Both assem-
blies are pre-lubricated and sealed, requiring no additional lubrication.
persists or became worse, contact our customer service department.
WATER INLET SCREEN (FILTER)
The Pressure Washer is equipped with a water inlet screen to
protect the pump from foreign debris.
CAREFULLY remove debris from the screen using a nonabra-
sive and dull object (finger or Q-Tip). Make sure screen is not
torn or broken.
place. Impurities entering pressure pump can cause internal damage.
COOLING SYSTEM
The air louvers, located in and around the Pressure Washer housing must be kept clean and
free of any obstructions to ensure proper air cooling of the motor and pump during operation.
Problem
Unit will not start (when trig-
ger is depressed)
A small amount of oil leakage is normal. If oil leakage
Do not operate Pressure Washer without screen filter in
TROUBLESHOOTING GUIDE
Probable Cause
1. Unit is not turned on.
2. Loose or disconnected
plug.
3. GFCI has tripped.
4. Thermal Switch has
tripped.
17
SCREEN
Solution
1. Press ON/OFF Switch into
ON position.
2. Reconnect Plug.
3. Push reset button on plug.
4. Allow to cool and restart
unit.