or exfoliation peelings helps to prevent
in-growing hair as the gentle scrubbing
action removes the upper skin layer and
fine hair can get through to the skin
surface.
Description
1a High frequency massaging rollers
1b Skin contact cap (only with model
5280)
2
Epilation head with tweezer element
3
Light
4
On/off switch
5
Release button
6
Special cord set
7
Shaver head attachment with
trimmer cap (only with model 5280)
8
Cooling glove
Preparing for use
• Your skin must be dry and free from
grease or cream.
• Before use, always make sure that
the epilation head (2) is clean and
provided with a cap (1).
• To change caps, press their lateral ribs
and pull off.
• To change heads, press the release
button (5).
Cooling glove for optional skin
cooling
For the first few epilations or if you have
sensitive skin, you can use the cooling
glove (8), recommended by dermatolo-
gists to help reduce possible skin
irritation.
• Ensure that the gel pack has been
in the deep freezer (***) for at least
2 hours (for convenience you can store
the gel packs in the freezer).
• Insert the gel pack underneath the
cooling glove's transparent foil. Use
only with glove.
• Put transparent (cool) side of the glove
on your leg.
• Start cooling for approximately
30 seconds, longer if needed.
• Epilate the cooled skin area immedi-
ately.
• Repeat cooling and epilating until
completion.
• While epilating, please ensure your
skin is dry.
Important: Apply cooling glove to the
same area for no longer than 2 minutes.
Keep away from sunlight. Do not use
gel pack when damaged. Dispose of
in household waste. Do not use if you
are hypersensitive, allergic to the cold,
or if your skin suffers from sensory
disturbances, when suffering from
cardiac diseases or arterial circulatory
disorders.
A How to epilate
The epilation head (2) features Close-
Grip Technology to ensure extra
efficiency especially with short hairs:
The 40 tweezers always keep close
contact to the skin to remove hairs as
short as grain of sand. The pivoting head
perfectly adapts to the body contours for
maximum thoroughness.
The high frequency massaging rollers
(1a) stimulate your skin effectively for an
extra gentle epilation.
The skin contact cap (1b) for fast
epilation ensures maximum skin contact,
positioning the tweezers at the optimal
position at all times.
1 Turning on
Turn the on/off switch (4) to operate
the appliance:
«I» = extra gentle
«II» = extra efficient
When switched on, the light (3) illumi-
nates the area to be epilated. This
gives you a better control for improved
epilation efficiency.
9