Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
8.- Place the screen on the
stand using the fastenings
bars (B), tighten them to
prevent movement.
It is recommended that this step is done, for safety, between two people.
3. ANGLE ADJUSTMENT AFTER INSTALLATION
1.- Once the screen is installed and fi rmly attached, locate
the knob on the adjustment bars.
2.- Loosen them slightly so that the screen moves.
3.- Adjust the screen at the desired angle (Until 15°).
The screws are standard size, we recommend refer to the instruction manual of your
screen for more information about the necessary screws to the mounting.
Steren is not responsible for material damages, nor personal injuries caused by wrong use
or wrong installation. The user is responsible of correct installation and continuous check.
Product design and specifi cations are subject to change without previous notice.
4.- Tight the knob.
The arm (C) has a screw to rotate the screen in
vertical axis 90° to 90° right or left.
Use the hole in the back of the stand to keep
cables more organized.
B
520-770mm
5
Publicidad
Tabla de contenido
