Samsung WF50A86 A Serie Manual Del Usuario página 24

Installation
STEP 3 Adjust the leveling feet
STEP 4 Connect the water hose
24 English
Untitled-1 24
1. Gently slide the washer into position. Excessive force
may damage the leveling feet.
2. Using a wrench, turn the leveling feet clockwise
or counterclockwise to adjust the height until the
washer is level.
3. Using a flathead screwdriver, tighten the locking
nuts (A).
NOTE
Use the open-end of the supplied wrench to adjust the
leveling feet.
CAUTION
• Make sure to use new water hoses and that rubber
gaskets (B) are inside the couplings (A) at both ends
of the hoses. Water hoses without the gaskets may
leak.
• Allow 5 in. (127 mm) of space between the back of
the washer and the wall to prevent water hoses from
being kinked. Kinked hoses may cause water leaks.
• If there is a water leak, stop using the washer and
contact a local Samsung service center. A water leak
B
may cause electric shock.
• Do not stretch the water hoses by force. If a hose is
too short, replace the hose with a longer hose.
A
2021-02-09 2:17:03