cecotec EXTREME 20 Guía De Uso página 10

ENGLISH
Step 5:
Take out the rails and align the four bar holes on the rails. The threaded hole on the fixed
seat cushion, flat pad into the cylinder head screws, and Lock with an allen wrench.
Step 6: Handlebar frame
Attach the HANDLEBAR FRAME onto the HANDLEBAR SUPPORT FRAME. Adjust to your
desired position and fix using LOCK KNOB and U-Shaped handle locking bracket (which
was pre-fitted inside of the Handlebar support frame).
To Tighten: Turn LOCK KNOB handle clockwise, then pull the handle upward and turn
counterclockwise to the starting position, repeat above operation to tighten the LOCK
KNOB.
To Loosen: Turn LOCK KNOB handle counter clockwise, then pull the handle upward and
turn clockwise to starting position. Repeat above operation to loosen the LOCK KNOB.
18
Step 7: Monitor
Attach the MONITOR holder bracket to the HANDLEBAR FRAME, fix using bolts.
Please note the "SENSOR" & "PULSE" contacts.
Step 8: Shifter
As shown in the figure of the brake ball head, the ball head clockwise rotation, Spinning
bike resistance increases, and vice versa. In case of emergency, please press your hand
to press the brake ball to press, and the car body will stop quickly and prevent injury.
Step 9: Stabilizers
The stabilizers are in the stabilizers bars. Use them if you have a soft uneven surface. Turn
the screw clockwise to remove the stabilizer and adjust to any size needed.
ENGLISH
19