Schema Of The Case - Astralpool POOLWATCH BASIC 16649 Manual De Instrucciones

6.2 SCHEMA OF THE CASE POOLWATCH BASIC pH / ORGANIC CHLORINE-BROMINE
7. PROGRAMMING AND ADJUSTMENT OF THE pH PROBE AND THE ORGANIC CHLORINE-BROMINE CELLS
Before switching on the PoolWatch Basic pH/organic Chlorine-Br it is recommended to have the water in the pool box
between 7-7.6 pH units and between 1-1.5 ppm of the free residual Chlorine (DPD nº1) or 2-3 ppm of the free residual
Bromine.
1.- Put the starter command of the dispenser pump in 0 position (off).
2.- Keep closed the inlet and outlet valve water to the analysis chamber.
3.- Take the pH electrode out of its original container.
4.- Connect the pH electrode to the wire connector on the left (corresponding to the connector 26 blue heald (-) and 27 active (+)
translucent.
5.- Fill the jug to calibrate with buffer solution pH 7. Put the buffer solution in the inferior part of the electrode. Follow the signal flow
graph planning of the equipment. Go to adjustment and select the pH parameter. Introduce "SENSOR pH" and press "ENTER". Some
bars will appear on the LCD screen. Once the calibration is finished, the sentence "STABLE READING" will appear on screen. We will
press validate (VAL), which will confirm a correct adjustment of the pH electrode.
6 .- Rinse the pH electrode with buffer solution pH 4 before doing the adjustment pH 4
7.- Fill the jug to calibrate with buffer solution pH 4. Do the same as before but using buffer solution pH 7.
POOLWATCH BASIC
6 6 7 7 1 2d 2a 1 2d 2a
KEYS DOUBLE FUNCTION
TEMPERATURE
DELAY
Key 2d
SENSOR READING
8 Ref: PW Basic-16649-16650-28470-30831-gb-v2-T01
C O N TR O L M IN O R
2c 2c 2b 2b 3 3 5 5 4 4
Key 2a
SENSOR SLOP
Key 2 b
Key 2c