Recoil Pull Starting; High Altitude Area Operation - LIFAN Power USA ESI3600iE Instrucciones De Uso Y Manual Del Propietario

Recoil Pull Starting

1. Open gasoline switch
2. Place the key into the ignition switch, and turn the key to 'ON' position.
3. Pull the starting rope until feel the resistance, then pull briskly to start the engine.
Do not allow the starter grip to snap back against the engine. Return it gently to prevent damage to the starter or housing.
If the engine will not start after being stopped, please check the oil level first.

3. High altitude area operation

At high altitude, the standard carburetor air/fuel mixture will be too rich. Performance will decrease, and fuel consumption will
increase. High altitude performance can be improved by specific modifications to the carburetor. If you always operate your
generator at altitudes above 5,000 feet (1,500 meters), please ask your Authorized EnergyStorm Service Center to properly jet the
carburetor for High Altitude use. Even with carburetor modifications, the engine horsepower will decrease about 3.5% for each
1,000-feet increase in altitude. The effect of altitude on horsepower will be greater than this if no carburetor modification is made.
When the carburetor has been modified for high altitude operation, this modified
Carburetor may cause the engine to overheat and result in serious engine damage.
(only for electric/recoil models)
ON
Recoil Start
Rope
Diagram #56010
13