Teuco 255 Instrucciones De Montaje página 25

VERIFICATION OF PLUMBING AND ELECTRICAL
CONNECTIONS
-
10
Having made all the connections, start the system up as
described in the accompanying user manual.
Check there are no leaks at connection points and that
everything is working as it should.
Push the bathtub and cabin against the wall, taking care not
to damage the waste connection made previously.
FITTING THE ALUMINIUM TRIMS
(version with towel rail panel only)
-
11
Push the aluminium trim onto the edge of the back panel.
FITTING THE TOWEL RAIL PANEL
-
12
Hook the bottom part of the towel rail panel over the
A
fixing brackets on the back panel, ensuring the side of the
towel rail panel fits into the aluminium trim on the back
panel.
-
12
Secure the top of the towel rail panel to the back panel
B
fixing brackets with screws and washers.
FIXING THE CABIN TO THE WALL
- HYDROSHOWER WITH TOWEL RAIL PANEL
-
13
Fit the angle brackets to the back panel with screws and
A
washers;
-
13
Drill the wall, using the slot in each bracket as a guide.
B
-
13
Use the fasteners kit (D) in the accessories bag.
C
Locate the spacers on the screws.
Insert the masonry plugs and fix the cabin to the wall.
Fit the concealers to the spacers.
FIXING THE CABIN TO THE WALL
- HYDROSHOWER WITHOUT TOWEL RAIL PANEL
-
13
Fit the angle brackets to the back panel with screws and
A
washers;
-
13
Drill the wall, using the slot in each bracket as a guide.
B
-
13
Use the fasteners kit (D) in the accessories bag.
C
Locate the spacers on the screws.
Insert the masonry plugs and fix the cabin to the wall.
Fit the concealers to the spacers.
ANCHORING THE HYDROSHOWER TO THE FLOOR
-
14
Fix the tub to the floor by securing the feet as
indicated in the illustration, using the screws and
plugs provided.
FITTING THE PANELS
-
15
Refit the panels removed previously, first panel 2, then
panel 1:
- offer the panel to the bathtub
- locate the top edge of the panel and press so that it
clips under the rim and against the springs.
- press in on the bottom part of the panel near the clips,
so that the pins snap into the sockets.
FIXING THE PANELS
16
-
Raise the panels using the wedge (A) provided.
- Secure the panels with the screws and collars (B).
- Snap the concealers (C) onto the collars.
WALL TRIMS
-
17
The pack of trims supplied covers all versions (A, B, C, D);
use only the parts required.
L1– L2 – Trims to be cut to size
L3 – L4 – Trims already to size
Apply silicone along the edges where the wall and
hydroshower meet.
Fit the trims with the angles and terminals, taking care to
ensure they are tight against the hydroshower and the
wall.
Apply adhesive tape to hold the trims in place; leave the
tape in place for at least 4 hours, then remove and clean
off excess sealant.
25