3. M
AINTENANCE
3.1 Q
UARTERLY
Unplug the unit.
Be careful while opening the door; water or small debris could fall out. For
HRV units, always wait one minute after disconnecting the unit before opening
the door in order to allow water to drain out from the unit.
Unlatch the door and open it. Clean the inner side
of the door with a damp cloth, then wipe with a
dry one. Disengage the door from its hinge by sliding
it from left to right and set aside.
Lift both foam filter brackets in order to
remove the foam filters from the core.
Wash the 2 core filters under hot water with mild soap. Rinse thoroughly and let dry
completely before reinstalling on the core.
Reinstall both foam filters and secure them to the core by pulling down the 2 foam
filter brackets. Reinstall the door.
Close the door and plug the unit.
NOTE: The unit will return to its previous setting after a 30-second delay for boot
sequence.
(
'
)
CONT
D
M
AINTENANCE
!
WARNING
VD0179
VB0078
6