Proxxon BSL 220/E Manual De Instrucciones página 10

The unit enables metal, plastic and wood to be
processed.
It can be used for regrinding moulds, grinding
small apertures and for polishing.
It can additionally be used for deburring and
breaking edges, removing paint and finely
grinding surfaces.
Turning is carried out via a maintenance-free
mitre gear.
The grinding belt is driven by a robust
aluminium drum which is equipped with a
double-bearing.
The tensioning roller is also equipped with ball
bearings.
The grinding head may be swivelled, so that
work in awkward places is also possible.
Technical data
Dimensions, weight:
Length
Weight
Grinding belt length
Head can be rotated by
Motor:
Voltage:
Power consumption:
Belt speed
Noise generated:
Vibration at handle
For use in dry environments only
Protection class II device
Please do not dispose off the
machine!
Accessories (included):
Replacement grinding belts (4 units)
- 10 -
approx. 330 mm
approx. 650 g
330 x 10 mm
60°
230 V, 50/60 Hz
100 W
300 bis 700 rpm
≤ 70 dB (A)
≤ 2.5 m/sec
2
Operation
Working with the unit.
Danger
Do not work without protective goggles and
protective mask.
1. Switch unit on at switch 2 (Fig. 2) and adjust
the speed at knob 1 in accordance with the
operation.
2. The grinding surface 2 (Fig. 3) is particularly
suitable for processing plane surfaces.
Curves are best processed with grinding
surface 1. Surface 3 is suitable for
operations in narrow apertures and cavities.
High grinding performance is achieved not by
applying excessive pressure but by employing
a correct and even belt speed.
Replacing the grinding belt
Attention!
Disconnect from the mains before replacing the
grinding belt.
1. Depress tensioning roller 1 (Fig. 4) axially
and remove grinding belt from the drive
roller (2).
2. First position new grinding belt around the
tensioning roller (1). Then press the
tensioning roller backwards and position the
belt over the drive roller (2).
Adjusting the grinding belt
The grinding belt must run in the vcentre of the
tensioning roller. If this is not the case, it must
be readjusted.
Danger!
Danger of injury!
1. Switch unit on
2. Select lowest speed
Note: