Changing Programs; Expanded Program; Setting The Speed Of The Cable Feed - Weidmuller Cutfix 8 Manual De Instrucciones

Setting up the machine

5.3 Changing programs

► Enter the number of the program that you want to
change.
► You can use the ↑↓ arrow keys to select the setting that
you want to change.
– 1 x press = Change piece quantity
– 2 x press = Change length
– 3 x press = Change correction
► To save the modified program, press SHIFT and Enter at
the same time.
► If you want to change additional programs, go back to
the program menu by pressing SHIFT and Enter simul-
taneously once more.
► To start the program, press Enter.

5.4 Expanded program

In addition to the settings for normal operation, you can
make the following settings in the expanded program.
– Partial quantity
– Partial quantity waiting time
– Motor waiting time
The expanded program is opened if you hold down the
SHIFT key when switching on the machine.

5.5 Setting the speed of the cable feed

The speed of the cable feed is displayed in per cent. The
maximum value 99% equates to 1.5 m/s.
If you set a cutting length > 1 m, you should al-
ways reduce the speed.
► Select a program.
► To increase the speed, press the -/+ button.
► To reduce the speed, press SHIFT and the -/+ key si-
multaneously.
The set speed is not saved in the program. It
remains active for all programs until the next
change.
26 2571390000/01/11.2017