Troubleshooting; Fault Table; Wear Parts - Weidmuller Cutfix 8 Manual De Instrucciones

8

Troubleshooting

If a fault cannot be resolved by means of the ac-
tions described here, please refer to Weidmüller
Service.

8.1 Fault table

Fault
Machine cannot be
switched on.
Increased scrap
Length deviation
Motor blocked.

8.2 Wear parts

Product
Cutting blade (set)
Double-sided toothed belt
Toothed belt (motor)
2571390000/01/11.2017
Possible cause
No power supply
Cutting blade damaged or blunt.
Setting shifted
Worn toothed belt
Slip
Cable feed sluggish
Order no.
9054740000
9054750000
9054760000
Recommended action
► Check the power cable and the mains con-
nections.
► Check fuses.
► Replace the blade (see section 8.4).
► Check the setting.
► Replace the toothed belt.
► Perform a slip correction
(see section 5.4).
► Check the cable feed.
► Adjust the speed of the cable feed.
31