Publicidad
Idiomas disponibles
Idiomas disponibles
FRONT PANEL FUNCTIONS
1962 BLUESBREAKER™ FRONT PANEL
MAINS
JTM
ON
1
1. MAINS
Mains power ON/OFF switch.
2. STANDBY
STANDBY is used in conjunction
with the MAINS power switch (Front
Panel Function #1) to 'warm up' the
amplifier before use and to prolong
the life of the output valves. When
powering up, always switch MAINS
power on first, leaving the STANDBY
switch in the 'standby' position. This
allows the application of the voltage
required to heat the valves to their
correct operating temperature. After
approximately two minutes the valves
will have reached the correct operating
temperature and the amplifier can be
engaged by switching MAINS power
ON.
Note: In order to prolong valve life, always
set the STANDBY switch to the 'standby'
position when turning the amplifier sound
on and off during breaks in performance.
Also, upon full power down, always put the
amplifier in 'standby' prior to switching off
the MAINS power.
3. INDICATOR
The power indicator will light when the
amplifier's mains power is switched on
STANDBY
ON
2
3
ENGLISH
SPEED
INTENSITY
4
6
4
2
8
2
0
10
0
4
5
and will be unlit when the mains power is
switched off.
4. SPEED
Controls the speed at which the
'tremelo' effect oscillates.
5. INTENSITY
Controls the depth of the 'tremelo'
effect's oscillation.
Note: 'Tremelo' will only work when playing
through Channel 2.
6. PRESENCE
Controls the overall amount of higher
frequency content in your sound. Turn
clockwise to add crispness and bite for a
more cutting tone. Presence is a power-
stage function and acts independently of
the preamp EQ controls.
7. BASS
Controls the amount of lower frequency
content, or bottom-end, in your sound.
Turning clockwise will increase the
bottom-end giving a fuller tone.
8. MIDDLE
Controls the middle frequency content
of your sound. Turning clockwise adds
girth. Turning anticlockwise reduces
PRESENCE
6
4
6
8
2
8
10
0
10
6
BASS
4
6
2
0
1
7
Publicidad
