Maintenance & Adjustments
Maintenance
Engine
Refer to the Engine Operator's Manual.
Shave Plate and Skid Shoes
The shave plate and skid shoes on the bottom of the snow
thrower are subject to wear. They should be checked periodically
and replaced when necessary.
NOTE: Deluxe skid shoes have two wear edges. When one side
wears out, they can be rotated 180° to use the other edge.
To remove the skid shoes:
1.
Remove the four carriage bolts and hex flange nuts which
secure them to the snow thrower.
2.
Reassemble the new skid shoes with the four carriage bolts
(two on each side) and hex flange nuts. Refer to Figure 6-1.
NOTE: Augers not shown for clarity
To remove the shave plate:
1.
Remove the carriage bolts and hex nuts which attach it to
the auger housing.
2.
Reassemble new shave plate, making sure heads of carriage
bolts are to the inside of housing. Tighten securely. Refer to
Figure 6-1.
Lubrication
Gear Shaft
The gear (hex) shaft should be lubricated at least once a season
or after every twenty-five (25) hours of operation.
1.
Run fuel tank dry, then carefully pivot the snow thrower up
and forward so that it rests on the auger housing.
16
Figure 6-1
2.
Remove the frame cover from the underside of the snow
thrower by removing the self-tapping screws which secure
it. Refer to Figure 6-2.
NOTE: Tracks removed for clarity
Figure 6-2
3.
Apply a light coating of engine oil (or 3-in-1 oil) to the hex
shaft. See Figure 6-3.
NOTE: When lubricating the hex shaft, be careful not to get
any oil on the aluminum drive plate or the rubber friction
wheel. Doing so will hinder the snow thrower's drive
system. Wipe off any excess or spilled oil.
Gear (Hex) Shaft
Figure 6-3
6
Friction Wheel