Assembly & Set-Up - Troy-Bilt Storm Tracker 2690XP Manual Del Operador

Assembly & Set-Up
Contents of Crate
• One Snow Thrower
• One Snow Thrower Operator's
Manual
• One Engine Manual
Assembly
Handle
1. Place the shift lever in the Forward-6 position.
2. Remove the lower plastic wing nut and carriage bolt from
each side of the upper handle; raise the upper handle
assembly until it snaps over the lower handle. See Figure
3-1.
NOTE: Make certain the cables are seated properly in the
roller guides. See Figure 3-2.
3. Looking beneath the handle panel, check that all of the
cables (steering, auger, shift, and drive) are properly routed
and not pinched or kinked.
4. Secure the handle by tightening the plastic knob located
on both the left and right sides of the handle. Remove
and discard any rubber bands, if present. They are for
packaging purposes only.
• Two Replacement Auger Shear Pins
• One Product Registration Card
• One Electric Start Cord
• One Chute Assembly
• One Chute Control Rod
Figure 3-1
Figure 3-2
3
7