Descargar Imprimir esta página

Weller Portasol P-1K Instrucciones Para El Manejo página 10

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Four tools in one
- Soldering iron
- Blow torch
- Hot blower
- Hot knife
Eliminates all risk of leakage current to sensitive circuits and
allows antistatic* soldering.
* Surface conductivity is approximately 10
Precision soldering for craftsmen and professionals
- The patened (U.S. Patent # 4785793) Portasol has a catalytic
converter for powerful yet flameless combustion.
- Adjustable temperature control, equivalent to 10 to 60 watts.
- Melts solder in less than 40 seconds.
- Lightweight, ergonomically designed, fully portable.
- Built-in flint spark ignition.
- Refill in 20 seconds with standard butane fuel.
- Up to 90 min. continuous use.
- Fuel not included.
Your Portasol P-1 contains flammable gas under pressure, use
with care. Keep out of reach of children. Refill away from flame
with standard butane lighter fuel. Keep your Portasol P-1 away
from face when igniting. Do ensure flames are extinguished be-
fore putting down. Hot gases emitted from all exhaust ports. Do
not expose to heat above 120°F (50°C) and avoid prolonged ex-
posure to the sun. Do not puncture or incinerate. Do not refill,
ignite or use near flame or combustible materials. Do not replace
cap without first switching off and ensuring tip has cooled. Do
not attempt to readjust our repair. This product is not user
serviceable. Always return the soldering equipment to its original
holder, when it is not needed.
NOTE:
Should the flames not extinguish within 30 seconds fit a
replacement tip.
Instructions
1. Gas filling
- Adapters are not normally required when
refilling.
- Hold unit vertically with the filling valve face
upwards. Push the gas refill cylinder onto the
filling valve.
- Make sure the on/off switch is in the off
position before filling. (Fuel not included.)
2. Ignition
Set the temperature regulator to mid position, then holdering
your Portasol P-1 away from the face and body, push the switch
towards the tip, this will release the gas. Activate the flint ignitor
with the other hand, holdering it in close proximity to the tip,
pointing the stream of sparks at the exhaust ports.
WARNING
Ω
12

Publicidad

loading