bloom fresco Manual Del Usaurio página 21

eng
inner face of seat unit. Slide the buckle on the
end of the waist straps into the buckle slots on
either side of the storage compartment. Close
the compartment door. Check the straps are
secured by pulling on the straps.
– (part #11) Place 'C' shaped clips located on
either side of the safety bar onto the side
posts and lock into position. You will hear an
audible click.
– Press down firmly on both sides of the safety
bar to ensure secure. The 'C' shaped clips
should be flush with the side posts.
– Place buckle on the end of the crotch strap
into the base of crotch bar, then slide into
seat unit. (The strap and buckle must not be
twisted or inverted. This will ensure correct
locking of the harness.)
– Adjust the length of the harness straps until it
fits firmly around your child.
WARNING: Always use the safety harness.
To remove the seat pad & safety harness for
cleaning, follow the instructions given in the care
& maintenance section of this instruction guide.
c5 Using and Adjusting the Safety Harness
Locking the safety harness:
Lock the harness by pushing the tongues on
the ends of the waist straps, connected with the
ends of the shoulder straps, into the buckle on
the crotch strap.
The harness will automatically lock when the
tongues have been fully pushed in. You will hear
an audible click.
6
Unlocking the safety harness:
Squeeze the ends of the tongues together and
then slide them out of the buckle.
Adjusting the shoulder straps height:
As your child grows you will need to alter the
height of the shoulder straps. The time to do this
is when the child's shoulders are above the slits
on the seat pad, where the shoulder straps pass
through.
NOTE: Every time you place your child in the
baby chair or whenever you alter the position
of the seat always check that the harness is
correctly fitted. Tighten the harness until it fits
snugly around your child.
c6 Mini Tray Assembly
– (part #03) Latch the hook located on the
bottom of the mini tray onto the safety bar
whilst rotating the tray downwards.
– Lock the mini tray into position by pressing
down on the left and right arm of the tray. The
pegs should snap into the holes on the tray.
You will hear an audible click.
– To remove the mini tray, reverse the order of
assembly steps.
– The mini tray is dishwasher safe, and is made
of FDA compliant food contact grade plastic
and stainless steel.
c7 Food Tray Assembly
– (part #04) Squeeze the left and right trigger
located under food tray simultaneously, whilst
sliding the food tray onto the mini tray, then