Attaching/Detaching the Lens
For information on how to attach and remove the lens,
refer to the operating instructions for your digital
camera.
• Before attaching or detaching the lens, check that the
digital camera is turned off.
• Before attaching the lens to the digital
camera, remove the lens rear cap by
rotating it in the direction of the arrow.
• To prevent dust and other particles
from accumulating on or entering the
lens, be sure to attach the lens cap/
lens rear cap after detaching the lens
from the digital camera.
∫
Attaching Filters
• Vignetting may occur if using 2 or more filters at the same
time.
• It is possible to attach the lens cap with the filter already
attached.
• When using the lens hood and a filter at the same time,
attach the filter first.
• You cannot attach a conversion lens or adaptor to this
lens. A filter may be used, but attaching any other element
may cause damage to the lens.
6
SQT1299
Using the Lens Hoods
∫ Attaching the Lens Hood (Supplied
Accessory)
1
Align the mark A (
the mark on the tip of the lens.
2
Rotate the lens hood in the direction of the
arrow until it clicks and then align the mark B
(
) on the lens hood with the mark on the
tip of the lens.
) on the lens hood with