Tabla de contenido
Publicidad
AUTO
SPEED
WIFI
WIFI Symbol*
9
8
NOTE: *
means only available for WIFI models. For more
information, please see the WIFI manual.
When the timer is not in use,
1.
Digital Display:
the operation mode and the set temperature will
be displayed. Time will be displayed under the
timer setting.
2.
and
Button:
control panel and remote to increase or decrease
the Set Temperature or Timer.
Temperature range: 61 ~88
3.
Power Button:
Turn the air conditioner on and
off.
4. Mode Button:
Press the mode button to cycle
through the various modes: Cool, Dry, Fan and
Auto.
1
AUTO
MODE
7
6
5
4
Use these buttons on the
or 16 ~31 .
Cool Mode: The cooling function allows the air
conditioner to cool the room and at the same time
reduces air
activate the cooling function. To optimize the
function of the air conditioner, adjust the
temperature and the speed by pressing the button
indicated.
Dry Mode: This function reduces the humidity of
the air to make the room more comfortable. Press
2
the MODE button to set the DRY mode. An
automatic function of alternating cooling cycles
and air fan is activated.
3
Fan Mode: This function only works when the air
conditioner is vented. Press the MODE button to
set the FAN mode. With pressing the FAN SPEED
button, the speed changes in the following
sequence: Hi, Med and Lo in FAN mode.
Auto Mode: In AUTO mode the unit automatically
chooses the mode of operation (COOL,DRY or
FAN).In this mode the temperature will be set
according to the room temperature (tested by the
temperature sensor which is incorporated in the
indoor unit.).
5. Timer Button:
panel and remote to set the Timer.
Timer Off: The timed stop is programmed by
pressing TIMER button. Set the rest time by
pressing the button
time displayed is to your demand then press
TIMER button again.
Timer On: When the unit is off, press TIMER
button at the first time, set the temperature with
pressing the button
button at the second time, set the rest time with
pressing the button
button at the third time, confirm the setting,
will show on the display.
Note: It can be set to automatically turn off or on
in 0.5-24 hours. Each press of the
buttons will increase or decrease the timer. The
Timer can be set in 0.5 hours increment below 10
hours and 1 hour increment for 10 hours or above.
The SET light will turn on while setting.
To cancel the set function, press the TIMER
button again.
9
humidity
. Press the MODE button to
Use these buttons on the control
or
or
or
until the rest
. Press TIMER
. Press TIMER
then it
Publicidad
Tabla de contenido
