Dimension Drawings - Fusion Signature Serie Instrucciones De Instalación

Dimension Drawings

Signature Series Side View
Dimension 6.5" Speakers
76 mm (3.0 in.)
133 mm (5.25 in.) 153 mm (6.0 in.)
A Sports model speaker is shown, but the dimensions are the
same for the Classic model speaker.
Sports Model Front View
Dimension 6.5" Speakers
176 mm
(6.9375 in.)
156 mm (6.125 in.) 176 mm
Classic Model Back View
4
7.7" Speakers 8.8" Speakers
82.5 mm (3.25 in.) 102.5 mm (4.05 in.)
184.9 mm (7.28 in.)
7.7" Speakers 8.8" Speakers
196 mm 224 mm (8.8 in.)
(7.6875 in.)
202 mm (7.95 in.)
(6.9375 in.)
Dimension 6.5" Speakers
200 mm (7.875 in.)
156 mm (6.125 in.)
Cleaning the Speakers
NOTE: When mounted correctly, these speakers are rated IP65
for protection in the harsh marine environment from the front of
the speaker. They are not designed to withstand high pressure
water spray, which may occur when you wash down your
vessel. Failure to carefully spray-clean the vessel may damage
the product and void the warranty.
Do not use harsh or solvent-based cleaners on the speakers.
Using such cleaners may damage the product and void the
warranty.
1
Clean all salt water and salt residue from the speaker grill
with a damp cloth soaked in fresh water.
2
Use a mild detergent to remove a heavy buildup of salt or
stains.
Troubleshooting
Before you contact your FUSION dealer or service center, you
should perform a few simple troubleshooting steps to help
diagnose the problem.
If the FUSION speaker has been installed by a professional
installation company, you should contact the company so the
technicians can assess the problem and advise you about
possible solutions.
There is no sound coming from the speakers
• Verify that all connections from the source device and/or the
amplifier are connected correctly to the speaker terminals.
The system lacks bass or high frequencies
• Verify that the correct wire polarity is observed between the
source and speakers.
The wires should be connected positive to positive and
negative to negative.
• Verify that the speakers are attached firmly to the mounting
surface.
The audio is distorted
• Verify that the source volume is not too loud for the speaker,
and reduce the volume if necessary.
• Verify that the panels surrounding the speaker on the vessel
are not rattling.
• Verify that the source device and/or the amplifier are
connected to the speaker terminals correctly.
• If the speaker is connected to an amplifier, verify that the
input level of the amplifier is matched to the output level of
the stereo. For more information, see the manual for the
amplifier.
The LED lights will not turn on
• Verify that all wiring connections are correct and tight.
The LEDs pulse with the bass notes of the music
• Install a FUSION LED voltage regulator (SG-VREGLED).
Specifications
Specification 6.5" Speakers 7.7" Speakers 8.8" Speakers
Max. power (Watts) 230 W
RMS power (Watts) 75 W
Efficiency (1 W/1 m) 90 dB
Frequency response 70 Hz to
(+ 3 dB) 22 kHz
7.7" Speakers
220 mm (8.6875 in.)
176 mm (6.9375 in.)
NOTICE
280 W 330 W
100 W 130 W
91 dB 91 dB
60 Hz to 50 Hz to
22 kHz 20 kHz
Installation Instructions