OPTIKA MICROSCOPES OPTIKAM EC2 Serie Manual De Instrucciones página 3

How to test your Camera
In order to check if your Camera works correctly, it's not necessary to put it into the microscope: it's enough to
connect it into the USB port, run Vision Lite using the icon on your desktop, select the right driver and check
whether the shown image is not totally black.
Select the right drivers
It's very easy:
For Optikam EC2 Camera you have to select the driver:
2 MP USB Camera
For Optikam B2 Camera you have to select the driver:
USB CAMERA
To use OPTIKA Vision Lite you have to tell the Software which is the Driver by selecting the microscope-shaped
icon.
Getting started with OPTIKA Vision Lite, a very easy measuring and documenta-
tion software
Run OPTIKA Vision Lite by clicking on its icon on your desktop.
Select the right Driver for capturing the image. Note that after choosing the driver and before capturing the image
you can set the brightness, saturation, gamma ecc..
Then you can capture the image.
The image is now ready for being manipulated using OPTIKA Vision Lite.
Page 3