Petsafe stubborn dog in-ground fence Manual De Adiestramiento Y Funcionamiento página 15

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

5. Select a portion of the laid out Boundary Wire that is straight and at least 50 feet long to test the Receiver Collar.
Place the Test Light Tool Contacts on the Contact Points on
the Receiver Collar (6B, 6C). Hold the Receiver Collar at your
dog's neck height with the Contact Points pointing up (6D)
and the Correction Level Button facing the Boundary Wire.
Start inside the containment area and slowly walk toward the
center of straight section of Boundary Wire until you hear the
warning tone (6E). When you hear the warning tone, you have
identified the Boundary Width distance (Static Correction
Zone). Two seconds after the warning tone, the test light will begin
to flash. This flashing light can aid you in identifying the Boundary
Width should you have difficulty hearing the tone. To avoid having
the Receiver Collar go into Over Correction Protection mode, walk
back into the Pet Area until the warning tone stops. If the Receiver
Collar does not tone at the desired range, adjust the Boundary Width
Control knob to obtain the desired range. Turning the Boundary
Width Control knob clockwise increases the Boundary Width while
turning it counterclockwise decreases it (6F). Repeat this activity as
needed until the Receiver Collar tones between 6 to 10 feet from
the Boundary Wire. If using a Double Loop layout, you may need to
increase the separation of the Boundary Wire and/or increase the size
of the Boundary Width to achieve the desired range.
6. Test in a number of different locations around the containment area until you are
satisfied that the system is functioning properly.
7. Next, walk all around the Pet Area to ensure there are no areas where the Receiver
Collar may activate from signals coupled onto buried wires or cables. Test the collar
in and around the inside of the house as well. As mentioned, cable and wires from
cable TV, electrical or telephone lines may conduct pet fencing signals inside and
outside the house that can activate the dog's collar accidentally. While rare, if this
occurs your Boundary Wire is probably too close to these outside lines and should
be moved or modified as shown in Figure (3A).
8. To test the run-through prevention feature, walk towards the Boundary Wire. The
Receiver Collar should tone and the Test Light should flash brighter as you enter the
run-through area (6G). If you are satisfied that your system is functioning properly, you
are ready to start burying the Boundary Wire. If the Receiver Collar did not tone or
the Test Light did not flash, see the "Troubleshooting" section.
6B
www.petsafe.net
Test Light Contacts
6D
6E
6F
2
5
2
6G
6C
Boundary
Wire
5
8
8
Boundary
Wire
15

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Hig11-11052

Tabla de contenido