Campbell Hausfeld CP5211 Manual Del Usuario página 3

Safety Guidelines (Continued)
Risk of electrocution:
a. This product is provided with a ground fault circuit
interrupter, GFCI, built into the power cord plug. Be
sure to inspect cord and GFCI prior to use. Any repair or
replacement of the power cord must be performed by
a qualified (licensed or certified) electrical technician.
If replacement of the plug or cord is needed, use only
identical replacement parts.
b. Never use an extension cord with this product.
c. Connect only to properly grounded outlet. Do not remove
ground pin.
d. Inspect cord before using - Do not use if cord is damaged.
e. Keep all electrical connections dry and off the ground.
f. Do not touch plug with wet hands.
g. Do not spray electrical apparatus and wiring.
TOOL USE AND CARE
Do not use pressure that exceeds the
operating pressure of any of the parts
(hoses, fi ttings, etc.) in the pressurized system. Ensure
all equipment and accessories are rated to withstand the
maximum working pressure of the unit.
a. Maintain the tool with care. A properly maintained tool
reduces the risk of problems and is easier to control.
b. Ensure safety devices are operating properly before each
use. DO NOT remove or modify any part of the gun or
unit.
c. NEVER operate the machine without all components
properly connected to the machine (handle, gun/wand
assembly, nozzle, etc.).
d. Point gun in safe direction. Unit will start spraying when
trigger is squeezed if "On/Off" switch is in "ON" position.
e. Know how to stop this product and bleed pressure
quickly. Be thoroughly familiar with the controls.
f. ALWAYS engage the trigger safety latch in the safe
position when spraying is stopped even if only for a few
moments.
g. NEVER permanently engage the trigger mechanism on
the gun.
h. ALWAYS follow detergent manufacturer's label
recommendations for proper use of detergents. Always
protect eyes, skin, and respiratory system from detergent
use.
i. NEVER disconnect the high pressure discharge hose
from the machine while the system is pressurized. To
depressurize machine, turn power and water supply off,
then press the gun trigger 2-3 times.
j. Unplug unit when not in use.
k. Follow the maintenance instructions specified in the
manual.
l. ALWAYS turn water supply "ON" before turning pressure
washer "ON." Running pump dry causes serious damage.
m. Do not operate the pressure washer with the inlet water
screen removed. Keep screen clear of debris and sediment.
n. NEVER operate pressure washer with broken or missing
parts. Check equipment regularly and repair or replace
worn or damaged parts immediately.
o. Use only the nozzles supplied with this machine.
p. NEVER leave the wand unattended while the machine is
running.
q. ALWAYS hold gun and wand firmly when starting and
operating the machine.
r. NEVER allow the unit to run with the trigger released
(off) for more than one minute. Resulting heat buildup
will damage the pump.
s. Release the trigger when changing from high to low
pressure modes. Failure to do so could result in damage to
the nozzle.
t. NEVER store the pressure washer outdoors or where it
could freeze. Freezing temperatures can seriously damage
the pump.
SERVICE
a. When servicing a tool, use only identical replacement
parts. Use only authorized parts.
The DANGER, WARNING, CAUTION, and NOTICE
notifications and instructions in this manual cannot
cover all possible conditions and situations that may
occur. It must be understood by the operator that
caution is a factor which cannot be built into this
product, but must be supplied by the operator.
www.campbellhausfeld.com
MODEL: CP5211, CP5216, CP5321
Equipment damage:
SAVE THESE INSTRUCTIONS
DO NOT DISCARD
3