Safety System; Start­up - Silvercrest SRNH 100 D3 Manual De Instrucciones E Indicaciones De Seguridad

Frequently check the heating pad
for wear or damage. If signs
thereof are detected, the heating
pad was used improperly or will
no longer heat up, it must first be
inspected by the manufacturer
before being switched on again.
If the power cord of the heating
pad is damaged, it must be re-
placed by the manufacturer or
its service department, or a simi-
larly qualified person, to avoid
hazards.
With the heating pad switched
on, never
– place objects on it (e.g. suitcases
or clothes baskets),
– place a heating source such
as a hot-water bottle, heating
pad or similar items on it. The
heating pad may otherwise be
damaged.
The electronic components inside
the control unit will heat up whilst
operating the heating pad. For
this reason, the control unit must
not be covered or be lying on the
heating pad during operation.
This poses a risk of injuries and /
or damage to the heating pad.
Always observe the information
on start-up, cleaning and care,
and storage.
Important safety instructions / Safety system / Start-up
If you have additional questions
on using our products, please
contact our Customer Service
Department.

Safety system

note: The heating pad is equipped with a safety
system. The electronic sensor technology prevents the
entire surface of the heating pad from overheating
by automatically switching off in the event of a fault.
If the safety system switches the heating pad off au-
tomatically due to a fault, then the function display
on the control unit
if the heating pad is switched on.
Please note that, for safety reasons, the heating
pad must not be used after a fault and must be
returned to the service address indicated.
Start­up
note: The heating pad may smell of plastic the first
time you use it, but this will disappear after a short
period of time.
To begin, first connect the control
heating pad with the plug-in connector
(see fig. B).
Position the heating pad on your back so that
the fastener for the neck section is in the throat
area.
Then close the fastener.
Then adjust the length of the belt around your
stomach and fit the two ends of the connector
together (see Fig. C) to fasten the belt.
To open the belt, press the two catches on the
connector at the same time (see Fig. C).
is no longer illuminated, even
1
to the
1
GB/MT
2
3
35