Extel AUDIOGLASS 651 Guía De Instalación Y Uso página 45

d. Selecting an "AUDIO"transmission code (contd.) (AG 652)
1 2 3
e. Test the locations of the roadside panel and the handset
1 To test the roadside panel, place it at a height of 1.6 metres.
2 To test the handset, place it at a height of approximately 1.5 metres on a wall or lay it on a table.
3 Press the call button on the roadside panel. The chime will sound on the handset (adjust the volume if
necessary). To speak, press the
4 Buttons and
the roadside panel.
6 If the quality of the communication is satisfactory, finish the test by moving around with handset.
7 TAKE THE BATTERIES OUT OF THE BACK OF THE ROADSIDE PANEL
8 The roadside panel is powered by the ACCESSGLASS box which also controls an electric strike
plate or lock and an automatic gate opener.
Handset 2 - Right button on roadside panel.
1 Set microswitch 2 on handset 2 to the same configuration as handset 1.
2 Set microswitch 3 on handset 2 to the same configuration as handset 1.
3 Enable programming by setting microswitch 5on the roadside panel to
Onand microswitch 1 on the handset to On.
4 Press the right button on the roadside panel.If correctly synchronised,
the LED behind the nameplate will flash green and red.
5 After programming, reset microswitch 5 on the roadside panel and
micros-witch 1on the handset to Off.
IMPORTANT : the handsets have an autonomy of approximately 8 hours.If
the batteries are recharged after becoming fully discharged, it may bene-
cessary to remove the batteries from each handset for a few seconds andre-
insert them. If there is still no connection, re-set the video door
phone(points 3, 4 and 5 on pages 5 and 6).
button on the handset.
work only if the ACCESSGLASS box is installed and a connection is made with
45GB