Volume Control; Aux Input Jack; Headphone Jack - Bigben TW11 Modo De Empleo

Light
Press the Light button to switch the lights ON or OFF
1. When there is no music or the device is paused: LIGHT BALL and BASE LIGHT flash with a
different pattern
2. When the music is on: the LIGHT BALL and BASE LIGHT flash repeatedly, in line with the music
volume

Volume control

Adjust the volume by pressing the "VOLUME +" or "VOLUME - " button

AUX input jack

1. Press the POWER button then press the MODE button repeatedly until the AUX green LED is on.
2. Connect the AUX connecting wire from the output jack of your personal player, such as a portable
MP3 player, to the AUX input jack.
3. Play the music from your personal player and adjust the volume
4. To turn off the unit, press the POWER button again.

Headphone jack

A Ф 3.5mm stereo headphones socket is provided. When you connect to the headphone socket,
please turn the volume down to its minimum to avoid damaging your ears or the headphones before
connecting. After connecting the headphones to the headphone jack, the speakers will be automatically
disconnected.
Warning: Prolonged exposure to high sound levels may permanently damage your hearing. You may
not hear some warning sounds while wearing these headphones.
WARNING! Risk of hearing impairment
• Set a low volume on the playback device before connecting the headphones to the
sound source.
• Avoid excessive volume, particularly over extended periods or frequent use. Excessive
volume can result in permanent hearing impairment.
- EN 5 -