Flex ALR 512 Instrucciones De Funcionamiento página 19

Rotational laser
Using batteries in the power tool
One of the accessories included with the
power tool is a battery housing which can
be used instead of the battery pack.
Required batteries:
– 4 x type D / 1.5 V
Note
When the battery housing is installed,
mains mode is not possible.
Batteries for the remote control
Note
The button configuration on the remote control
corresponds to the buttons on the ALR.
The device cannot be completely switched off
with the remote control. To save energy, the
remote control switches off the laser beam and
rotation only.
Required batteries:
– 1 x 9 V-unit.
n Push down and remove the battery
compartment cover from the remote
control.
n Insert the 9 V unit as indicated.
n Close the battery compartment cover.
Batteries for the receiver
Required batteries:
– 2 x type AA / 1.5 V.
n Unscrew the battery compartment cover
on the receiver in an anti-clockwise
direction.
n Insert the batteries as indicated.
n Screw on the battery compartment cover
in a clockwise direction.
Switching the power tool on
and off
Switch on the machine:
n Press the On/Off button (10) on the
machine.
Switch off the machine:
n Press the On/Off button on the machine
or
Press the Off button on the remote
control.
Note
When switched on, the power tool always
starts in the "rotating laser beam" operating
mode.
Changing the speed of rotation
To reduce the speed of rotation in "rotating
laser beam" standard operating mode:
n Press the Shift button (16) on the device
or remote control once. The beam
rotates at a reduced speed.
To increase the rotation speed again:
n Press the Shift button (16) on the device
or remote control. The beam rotates at
high speed.
19