American Standard Studio-S 4803350 Instrucciones De Instalación página 2

2
MAKE WATER SUPPLY CONNECTIONS
• Turn off hot and cold water supplies before beginning.
• Connect FLEXIBLE SUPPLY HOSES (1, 2) directly to wall
supplies. Connection on fitting supplies are 3/8"
compression. Connect left supply hose (Red Stripe) to Hot
wall supply. Connect right supply hose (Blue Stripe) to Cold
wall supply. Use adjustable wrench to tighten connections.
Do not over tighten.
* Faucet supplies are 21" long from faucet base.
• Note: If additional supply length is required, installer
must purchase additional parts separately.
• Important: If SUPPLY HOSES (1, 2) are too long,
loop as illustrated to avoid kinking.
3
CONNECT SPRAY HOSE
• Push the SPRAY HOSE END (2) into the HOSE
CONNECTOR (1) slide down LOCKING COLLAR (3)
until it snaps into place to secure connection.
4
CHECK CONNECTIONS FOR LEAKS
• Move HANDLE into "off" position.
• Turn on water supplies and check connections for leaks.
• Operate HANDLE up and down, left and right to
flushwater lines thoroughly.
• Operate HAND SPRAY and check connections for leaks.
CHECK CONNECTIONS
FOR LEAKS
R E D
S T R I P E
HOT
- 2 -
B L U E
S T R I P E
2
COLD
1
1
2
3
M985012 (3/19)