Tabla De Contenido; Cleaning The Filter - Uline ROOMBA 960 Manual Del Usuario

To keep Roomba running at peak performance, perform
the following care procedures. If you notice Roomba
picking up less debris from your floor, then empty the
bin, clean the filter and clean the extractors.
PART CARE
FREQUENCY
Bin
After each use
Once per week
Filter
(twice per week in
homes with pets)
Full Bin Sensors
Once every 2 weeks
Front Caster Wheel
Side Brush
Cliff Sensors
Charging Contacts
Once per month
iAdapt Localization
Camera
Floor Tracking
Sensor
Once every 4
months (once every
Extractors
3 months in homes
with pets)
NOTE: For replacement parts, contact Uline.
EMPTYING THE BIN
1. Press bin release
button to remove
bin. (See Figure 4)
2. Open bin door to
empty bin.
(See Figure 5)
NOTE: If the full bin indicator ( ) comes on
at any time during a cleaning job, you can
always pause the cleaning job to empty the
bin and then continue cleaning.
If the full bin indicator is illuminated, but
the bin does not appear to be full, refer to
Cleaning the Full Bin Sensors.
PAGE 6 OF 24
REPLACEMENT
FREQUENCY
Every 2 months
Every 6-12
months
Figure 4
Figure 5
CARE

CLEANING THE FILTER

3. Remove filter
by grasping the
yellow tab.
(See Figure 6)
-
4. Shake off debris
-
by tapping the
filter against your
trash container.
(See Figure 7)
-
IMPORTANT! The filter door won't close unless a
filter is reinserted. Insert the filter with the yellow
tab facing up.
CLEANING THE FULL BIN SENSORS
1. Remove and
empty the bin.
(See Figure 8)
2. Wipe the sensors
with a clean, dry
cloth.
(See Figure 9)
3. Wipe the inner
and outer sensor
ports on the bin
with a clean, dry
cloth.
(See Figure 10)
Figure 10
Figure 6
Figure 7
Figure 8
Figure 9
Inner
Sensor
Outer Sensor Ports
Ports
0417 IH-6472