Remove And; Wipe The Sensors; With A Clean, Dry Cloth. (See Figure 10); Figure 11 - Uline ROOMBA 960 Manual Del Usuario

CLEANING THE FRONT CASTER WHEEL
1. Pull firmly on the
front wheel to
remove it.
(See Figure 11)
2. Remove any
debris from inside
the wheel cavity.
3. Spin the wheel by
hand. If rotation is
restricted, remove
the wheel from its
housing and push
firmly to remove
the axle and
clear any debris
or hair wrapped
around it.
4. Reinstall all parts when finished. Make sure the
wheel clicks back into place.
CLEANING THE SIDE BRUSH
1. Use a coin or
small screwdriver
to remove the
screw.
(See Figure 12)
2. Remove the brush,
clean the brush
and the brush
post, and reinstall
the brush.
CLEANING THE SENSOR AND CHARGING
CONTACTS
1. Wipe the sensor
with a clean, dry
cloth. Do not
spray cleaning
solution directly
onto the sensors
or sensor
openings.
(See Figure 13)
PAGE 7 OF 24
CARE CONTINUED

Figure 11

Wheel
Axle
Housing
Figure 13
Floor
Tracking
Sensor
2. Wipe the charging contacts on Roomba and the
Home Base with a clean, dry cloth. (See Figure 14)
Figure 14
CLEANING THE EXTRACTORS
1. Pinch the yellow
extractor frame
release tabs, lift up
the extractor frame
and remove any
obstructions.
(See Figure 15)
2. Remove the
extractors and
Figure 12
remove the yellow
extractor caps.
Remove any hair
or debris that
has collected
underneath the
caps and around
the metal axles.
Reinstall the
extractor caps.
(See Figure 16)
3. Remove hair
and debris from
the square and
hexagonal plastic
pegs on the
other side of the
extractors.
(See Figure 17)
4. Clear the vacuum
path. (See Figure 18)
5. Reinstall the
extractors. Match
the color and
shape of the
extractor pegs with the color and shape of the
extractor icons on the cleaning head module.
Charging Contacts
Figure 15
Figure 16
Figure 17
Figure 18
Charging Contacts
0417 IH-6472