Technical Data; Maintenance/Care - Würth ERGOPOWER DUAL Traducción De Las Instrucciones De Uso Originales

Technical data

Operating -10 – +40 °C
temperature
Storage temperature -20 – +45 °C
Protection type
Lamp IP65 (waterjet-proof)
Mains plug IP44 (splash-water-proof)
Protection class II / Protective insulation
Housing IK 09, impact- and fracture-resistant
Mains input 100 – 240 V~, 50/60 Hz
Charger input 12 V= or 24 V=
Charger output 8.4 V= max. 1 A
Nominal power 25 W (100 %) / 10 W (40 %)
Battery type Lithium-ion, permanently installed
Battery capacity 7,800 mAh up to
500 charging cycles
Charging time max. 6 h
Hours of illumination 2.5 h (100 %) / 6 h (40 %)
Bulbs SMD LEDs, permanently installed
Service life 2,400 h
2,500 lm (100 %)/1,000 lm (40 %)
Colour temperature 5,650 – 6,500 K
Radiation angle 120°
Dimensions 287 × 218 × 108 mm
Mass (weight) approx. 3 kg

Maintenance/care

Visual inspection before starting work
The device is maintenance-free. The lamp and its
accessories must nevertheless be checked for external
damage before each use.
The device may not be used when damage
is visible. It must be repaired or disposed of by an
electrician.
Cleaning
Cleaning work may only be performed when the
been disconnected.
Clean the device by wiping it with a soft, clean
cloth. Remove stubborn dirt with a moistened cloth
and a common household cleaner. Using cleaning
agents that are abrasive or contain alcohol or solvent
will damage the housing.
Disposal
Do not dispose of the device with domestic
waste!
Small electrical devices and packaging
must always be recycled in an environ-
mentally appropriate manner.
Electrical tools that are no longer usable
must be separately collected and for-
warded for environmentally appropriate recycling
according to the European Directive 2012/19/EU.
Warranty
(proof by invoice or delivery note) for this device.
A damaged machine is either repaired or replaced
with a substitute machine. Damage resulting from
improper handling is excluded from the warranty.
Complaints can only be accepted if the device is
handed over assembled to a Würth branch, your
Würth sales representative or a Würth-authorised
customer service centre.
9