WEG IOC-01 Guía De Instalación, Configuración Y Operación página 6

Installation, Configuration and operation guide
To correctly install modules IOC-01, IOC-02 and IOC-03, follow the steps below:
Step 1: While the drive is powered off, remove the front cover of the CFW-11 (figure 2).
Step 2: Carefully connect the module into slot 1 (figure 3(a)).
Step 3: Place and tighten the securing screw of the module (figure 3(b)).
Step 4: Connect the signal cables to the XC15 (IOC-01) or XC16 (IOC-02) terminal strip.
a
6
Figure 2: Removal of front cover
a
Figure 3: Installation of optional module into slot
b
b
c