Lutron HomeWorks HWI-KP5 Instrucciones Para La Instalación página 3

Installation
1.
Disconnect power to the keypads by turning off
all circuit breakers connected to the HomeWorks
Interactive Processor or keypad link auxiliary
power supply. Wiring with power ON may
result in personal injury.
2.
Address keypads. Assign a unique address to
each keypad using the DIP switch settings. See
Figure 2 (on right) for DIP switch location. See
Figure 3 (page 3) for DIP switch settings. Be
sure to record the address for future
programming purposes.
3.
Strip insulation or trim wires to 3/8" (10mm).
Each terminal will accept one or two
No. 18-gauge (1.0mm
4.
Unplug terminal block from the keypad circuit
board.
5.
Connect wiring to terminal block as shown in
Figures 1 and 2 (page 3).
6.
Plug the keypad terminal block back onto the
circuit board. Be sure to orient the terminal block
correctly.
7.
Mount keypad as shown in Figure 4 (page 4). Do
not over-tighten mounting screws.
8.
Restore power to the HomeWorks Interactive
panel.
Figure 1: HomeWorks Interactive Processor with HWI-KP5 keypads
Keypads can be connected to any of
these three terminals depending on
the configuration of the HomeWorks
Interactive Utility
1 2 3 4 1 2 3 4
1 2 3 4 5 6 7 8 J3
G1 V1 G2 V2 G3 V3 G4 V4
2
) wires.
8 8
1 2 3 4 1 2 3 4 1 2 3 4
1 2 3 4 5 6 7 8 J4 1 2 3 4 5 6 7 8 J5
G5 V5 G6 VG G7 V7 G8 V8 G9 V9 G10 V10 G11 V11 G12 V12
1 2 3 4
Figure 2: Rear View of Keypad
PELV (Class 2: USA)
MUX
Wiring connections to
MUX
HomeWorks Interactive +15V
COM
Panel or other Keypads
Pins 1 & 2 - 1 pair No. 18 AWG (1.0mm
Pins 3 & 4 - 1 pair No. 18-22 AWG (1.0 - 0.5mm
twisted/shielded for data
DIP switch for
setting address
2
) for power
2
)
3