Casio fx-9860GII SD Guia Del Usuario página 434

3. To change the sampling interval setting, move the highlighting to "Interval". Next, press
1 to display a dialog box for specifying the sampling interval.
• The range of values you can select depends on the current sampling mode setting.
If this sampling mode is selected:
Realtime
Fast
Extended
Period
Sound
Clock
Normal
4. To change the number of samples setting, move the highlighting to "Number". Next, press
1 to display a dialog box for specifying the number of samples.
• The total sampling time shown at the bottom of the dialog box is calculated by
multiplying the "Sampling Interval" value you specified in step 3 by the number of
samples you specify here.
Important!
• When all of the following conditions exist, a "Distance" setting appears in place of the
"Number" setting. See "To configure the Distance setting" (page 3-7) for information
about configuring the "Distance" setting.
• Channel Setup (page 3-3): 2(VRNR) - [Photogate] - [Pulley],
• Sampling Mode (page 3-5): Clock
5. To change the warm-up time setting, move the highlighting to "Warm-up". Next, perform
one of the function key operations described below.
Note
• The "Warm-up" setting will not be displayed on the Sample Setup screen if "Fast",
"Sound" or "Extended" is currently selected as the sampling mode.
To do this:
Have the warm-up time for each sensor set automatically
Input a warm-up time, in seconds, manually
Disable the warm-up time
Important!
• When the following condition exists, an "FFT Graph" setting appears in place of the
"Warm-up" setting. See "To configure the FFT Graph setting" (page 3-7) for information
about configuring the "FFT Graph" setting.
• Sampling Mode (page 3-5): Fast
3-6
Using Advanced Setup
This is the allowable setting range:
0.2 to 299 sec
20 to 500 μ sec
5 to 240 min
"=Trigger" only (no value input required)
20 to 27 μ sec
"=Trigger" only (no value input required)
0.0005 to 299 sec
3(CMA) - [Photogate] - [Pulley]
Press this key:
1(Auto)
2(Man)
3(None)