mail@graf.info
www.graf.info
1.
General information
1.1
Safety
All work should be undertaken in compliance with the relevant accident prevention regulations according
to BGV C22. A second person is required for safety reasons, particularly when inspecting the shaft.
In addition, the applicable regulations and standards must be respected during installation, assembly,
maintenance, repairs etc. Relevant information can be found in the corresponding sections of these in-
structions.
The entire system must always be switched off and secured against unauthorised resetting during any
work on the system or system components.
The shaft cover must always be kept closed, except during work on the shaft, otherwise the risk of acci-
dents is high. The fit of the cover should be regularly checked. Only original GRAF covers, or covers ap-
proved by GRAF in writing, are to be used.
GRAF provides an extensive range of accessories, which are all coordinated and can be combined to
form complete systems. The use of accessories that have not been approved by GRAF results in the ex-
clusion of the warranty/guarantee.
14 / 48