Assembly - Raven B463 El Manual Del Propietario

ASSEMBLY INSTRUCTIONS
CAUTION
Before assembling your RAVEN Grass Catcher to you
MPV:
• Locate your MPV on a firm and level surface.
• Set parking brake.
• Place all motion controls to "NEUTRAL".
• Turn ignition to "OFF" and remove the key.
• Ensure that the blades and all moving parts have
completely stopped.
• Disconnect the spark plug and place wire where it
cannot come in contact with the plug.
Wear ANSI-approved eye protection and work gloves
when assembling this unit.
High Lift Blade Installation
For more detailed instructions concerning removing the
mower deck and the installation of new mower blades,
please refer to your MPV Owner's Manual.
1. Turn the deck over - this requires two people.
2. Use a 17mm socket wrench to remove the old locking
nut and discard. Remove the domed washer and set
aside.
3. Remove the old blades.
4. Fit the high-lift mulch blades included with the bagger
assembly onto the blade adapter with the blade text
showing
www.ravenamerica.com
D142100 R1 Bagger Manual_Final - English.indd 7
New Blade
Blade Adapter
Text on Blades
5. Replace the domed washer onto the new blades with
the curved side up (Fig. D).
Seat Blade on Adapter
6. Thread the new locking nut onto the stud and use a
torque wrench to tighten to 40 ft/lbs.
NOTE: Ensure the blade is seated properly on the
blade adapter before torquing down the locking nut.
Tighten to 40 ft/lbs
7. Carefully turn the deck back over and reattach to your
MPV.
a
SSembly
Domed Washer
Curved Side Up
17mm Socket
Wrench
7
4/9/2015 8:50:25 AM